XDev Board
Features:
  • 400MHz XMOS processor with 8 hardware threads
  • Loads 64KB programs
  • JTAG debug and serial port communication over USB (no drivers required!)
  • 1 Megabyte of flash memory storage
  • Efficient voltage converters (Arduino and variants are inefficient)
  • 15 universal I/O pins
  • Max I/O speed: 60 MHz
  • Common reset pin
  • 2 Amps @ 3.3V to power expansion boards
  • Uses the "standard" DC barrel power jack
  • Can be powered by USB

Template Files
Features:

Full Breakout
Features:
  • You get three of these expansion boards when you choose this!
  • Breaks out every pin for easy access
  • Prototyping area
  • Uses all remaining lines! ("topper" board)

Partial Breakout
Features:
  • You get three of these expansion boards when you choose this!
  • Breaks out 3 pins (great for [most] SPI or I2C/UART + Interrupt)
  • Prototyping area
  • Uses 3 lines

IO Expander
Features:
  • 40 individually programmable lines (GPIO, interrupt or 8-bit bus)
  • Prototyping area
  • Uses 3 lines

SD Card
Features:
  • Supports both SD and SDHC cards (MiniSD and MicroSD using adapter)
  • FAT filesystem support is prewritten
  • Raw read/write operations supported
  • Fancy "push to eject" card slot
  • Uses 4 lines

IMU
Features:
  • 9 degrees of freedom
  • Three axis magnetometer (compass)
  • Three axis accelerometer
  • Three axis gyroscope
  • Built-in stability filter (MPU-6050)
  • Interrupt for event detection (like free falling)
  • Uses 3 lines

ZigBee
Features:
  • Wireless communication with other Zigbee devices
  • Uses a chip antenna for a minimal footprint
  • Uses 3 lines

Audio
Features:
  • A compact SMD speaker for audio output
  • A stereo headphone jack
  • Great for chiptunes
  • Uses 2 lines

LiPo/NIHM Battery
Features:
  • Supplies power for Power Supply Chain
  • Uses battery packs 6V or higher
  • Current use sensing
  • Battery monitor
  • Programmable low battery interrupt
  • Automatic power off to prevent battery damage
  • Uses 3 lines

Dual Motor Driver
Features:
  • Controls two DC motors
  • Uses Power Supply Chain
  • Current use sensing
  • Motor stall interrupt
  • Uses 3 lines

Dual Stepper Driver
Features:
  • Controls two Stepper motors
  • Uses Power Supply Chain
  • Up to 2 Amps per stepper motor
  • 1/16 step microstepping
  • Uses 2 lines

Servo Controller
Features:
  • Controls up to 24 servos including digital servos
  • Uses Power Supply Chain
  • On-board power converter for servos up to 10A
  • Uses 2 lines

Valid HTML 4.01 Strict
Valid CSS!